UPS for IT & sensitive equipment
No break, no dirty supply, no corrupted data.
For servers, networks, clinical instruments and control rooms: protection that holds the supply clean and unbroken so equipment isn't damaged and work isn't lost mid‑transaction.
Sized to the equipment and the time it needs to shut down safely.
The situation now
The damage happens in the half second nobody sees
Equipment restarts hard
Servers, switches and instruments drop mid‑operation — corrupted records, failed transactions and hardware that ages fast.
The supply is dirty, not just absent
Sags, spikes and unstable voltage quietly shorten the life of the most expensive equipment on the site.
The UPS was sized by guesswork
It beeps for three minutes and dies before anything can be shut down properly, let alone kept running.
The cost isn't the outage. It's the record that was mid‑write, the instrument that needs recalibration, and the hardware replaced years early.
How this system gets there
Clean, unbroken supply for the equipment that can't take a break
Step 1
Inventory the sensitive load
Servers, network, instruments and control equipment, with what each one actually draws.
Step 2
Decide ride‑through or run‑through
Whether you need a safe shutdown window or continuous operation — a different system for each.
Step 3
Size the UPS and its interface
Capacity, runtime and how it sits alongside any inverter, generator or backup already on site.
Step 4
Install, commission, test under load
Commissioned and tested so you have seen it hold the equipment before you rely on it.
Not sure yet?
That's normal. A power system is a big investment, so here are the questions clients ask most before they commit, and what we do about each one.
You might be thinking
“Is a UPS enough, or do we need backup too?”
What we do
We'll tell you which problem you actually have
A UPS protects the moment of transition; longer outages need battery backup. The assessment says which you need.
You might be thinking
“Will it work with our existing backup?”
What we do
Coordination is part of the design
Existing inverters, batteries and generators are assessed so the UPS complements them instead of fighting them.
You might be thinking
“What about our racks and cabling?”
What we do
The installation covers the environment
Placement, ventilation and cabling are handled as part of the works, not left to you.
Send us the rack list and what a break would cost you
We assess the sensitive load, size protection to the shutdown or run‑through you need, and come back with the proposal and the quote.
Often considered alongside
Start with the list of what you need to keep running
Send us the equipment and how long you need it to run without mains power. We do the load assessment, design the system and come back to you with a proposal and a quote.